board.h

Go to the documentation of this file.

/* Copyright 2018 Wirepas Ltd. All Rights Reserved.
 *
 * See file LICENSE.txt for full license details.
 *
 */
 
#ifndef BOARD_SILABSEFR32KIT_BOARD_H_
#define BOARD_SILABSEFR32KIT_BOARD_H_
 
// NOTE! The VCOM on the kit board supports ONLY the standart baud rates
// e.g. 125000 is not working.
 
// Serial port
#define BOARD_USART_ID                  0
#define BOARD_USART_TX_PORT             GPIOA
#define BOARD_USART_TX_PIN              0
#define BOARD_USART_RX_PORT             GPIOA
#define BOARD_USART_RX_PIN              1
 
// ROUTELOC are dependent on GPIO defined above and mapping
// can be founded chip datasheet from Silabs
#define BOARD_USART_ROUTELOC_RXLOC      USART_ROUTELOC0_RXLOC_LOC0
#define BOARD_USART_ROUTELOC_TXLOC      USART_ROUTELOC0_TXLOC_LOC0
 
// For further information about Silicon Labs Kit board pin configuration see:
// UG265: EFR32FG12 2400/868 MHz 10 dBm Wireless Starter Kit User's Guide
 
// List of GPIO pins
#define BOARD_GPIO_PIN_LIST            {{GPIOF, 4}, /* PF04 */\
                                        {GPIOF, 5}, /* PF05 */\
                                        {GPIOF, 6}, /* PF06 */\
                                        {GPIOF, 7}, /* PF07 */\
                                        {GPIOA, 1}, /* PA01. required by the dual_mcu app. usart wakeup pin (= BOARD_USART_RX) */\
                                        {GPIOD, 8}, /* PD08. required by the dual_mcu app (indication signal) */\
                                        {GPIOA, 5}} /* PA05. usart vcom pin */
 
// User friendly name for GPIOs (IDs mapped to the BOARD_GPIO_PIN_LIST table)
#define BOARD_GPIO_ID_LED0              0  // mapped to pin PF04
#define BOARD_GPIO_ID_LED1              1  // mapped to pin PF05
#define BOARD_GPIO_ID_BUTTON0           2  // mapped to pin PF06
#define BOARD_GPIO_ID_BUTTON1           3  // mapped to pin PF07
#define BOARD_GPIO_ID_USART_WAKEUP      4  // mapped to pin PA01
#define BOARD_GPIO_ID_UART_IRQ          5  // mapped to pin PD08
#define BOARD_GPIO_ID_VCOM_ENABLE       6  // mapped to pin PA05
 
// List of LED IDs
#define BOARD_LED_ID_LIST              {BOARD_GPIO_ID_LED0, BOARD_GPIO_ID_LED1}
 
// Active high polarity for LEDs
#define BOARD_LED_ACTIVE_LOW false
 
// List of button IDs
#define BOARD_BUTTON_ID_LIST           {BOARD_GPIO_ID_BUTTON0, BOARD_GPIO_ID_BUTTON1}
 
// Active low polarity for buttons
#define BOARD_BUTTON_ACTIVE_LOW true
 
// Board has external pull-up for buttons
#define BOARD_BUTTON_INTERNAL_PULL false
 
 
#endif /* BOARD_SILABSEFR32KIT_BOARD_H_ */